Skip to content
Docs
CLI
serverlessd run

serverlessd run

Runs the full serverless runtime.

The amount of memory needed is determined by the pods and pods-per-worker options.

Example:

serverlessd run --port 8080 --host 0.0.0.0 --pods 10 --workers-per-pod 2

You get 10 * 2 = 20, a maximum of 20 workers.

--debug

Whether to enable debug mode and show verbose logs.

--port <PORT>

Assigns the port to use. Defaults to 3000.

--host <HOST>

Assigns the host to use. Defaults to 127.0.0.1.

--pods <PODS>

The number of pods (threads) for serverless execution. You can put as many threads as your hardware allows.

--workers-per-pod <WORKERS_PER_POD>

The number of workers per pod (thread) for serverless execution.

It’s recommended to use a lower amount (about 2~3) so the delay between switching await points (which is usually caused by CPU tasks) from worker to worker can be reduced.